All our anti-drip nozzles have a 12/24 thread, .2mm and a .008″ orifice which will produce .016 GPM with a 55° spray pattern when pressurized at 1000 psi. Other nozzles sizes are available on request to meet all requirements.
Ultra-fine brass atomizing anti-drip nozzle with a stainless steel insert and complete with an O-Ring seal that can be hand tightened. The nozzle is designed with a ball and spring to stop the flow of mist once the water source is shut off. The nozzle can be disassembled for easy cleaning.
Our patented misting anti drip nozzles are designed to accomplish an extremely high emission velocity with a low flow rate. Liquids are atomized into aerosol particles, which flash-evaporate evenly into the environment, creating an ultra-fine mist. Our misting nozzles will atomize liquid even in climates with fairly high relative humidity with a very low increase of humidity.
The misting nozzle size allows it to be placed into small confined spaced. No wrench is needed for tightening. The self-sealing O-ring provides a leak proof seal that means no Teflon tape or sealant is required. The O-rings and ball stem are Viton, for better wear when used in harsh environments, high calcium or any kid of chemical.
Our misting nozzles create an extremely fine fog and each water droplet is less than 50 microns in size (1/10th. the size of a human hair.) The pin (impeller), orifice, and nozzle body are designed in such a way that when fluid is forced through, a very fine cone-shaped fog is created. Our misting nozzles are ideal for outdoor cooling, greenhouse misting, humidification systems, warehouse cooling, special effects fogging and all types of industrial misting and cooling systems.
Clogged nozzles that have calcium build up can be cleaned by soaking them in CLR or a half white vinegar and water solution for 15 to 30 minutes. Before you re-install the nozzles, rinse each nozzle thoroughly and make sure you flush each nozzle port before re-installing each nozzle.
Please order carefully. We cannot exchange anti-drip nozzles that were ordered with the incorrect orifice size, thread size, or for the incorrect system pressure (psi).
|Dimensions||0.75 x 0.375 x 0.375 in|